Knowledge is power, power is useful when you are stimming

Nipple Clamp Electrodes

Product applicability

Product Type Bi-Polar Nipple Clamp Electrodes
SKU Codes A1x1 etc

Materials And Design

These nipple clamp electrode combinations are made from several body-safe materials. The plastic insulator bodies are made from PLA or vapour-smoothed ABS, depending on the model. The conductive rubber loops are made from high-quality British conductive rubber.

Conductive rubber (a silicone elastomer) is created with carbon particles suspended within the silicone blend; this carbon element turns silicone into conductive silicone. In use, some black residue may be seen on your fingers or other body parts; this is normal and a result of outer layers of carbon shedding due to stretching and flexing.

The plastic insulators create the clamping effect while the conductive rubber acts as the electrode surfaces.

General And Nipple Play Safety Considerations

GENERAL E-STIM SAFETY - DO NOT CONNECT ANY ELECTRICAL DEVICE TO ANY LOCATION ABOVE THE WAIST (ACROSS THE ARMS COUNTS AS ABOVE THE WAIST!), BUT ESPECIALLY DO NOT CONNECT ACROSS THE HEART (FRONT TO BACK, OR SIDE TO SIDE), CHEST, NECK OR HEAD. DO NOT USE IF FITTED WITH A PACEMAKER OR OTHER ELECTRONIC MEDICAL IMPLANT, ARE EPILEPTIC OR ARE OR MAYBE PREGNANT. REMEMBER YOU USE THIS DEVICE AT YOUR OWN RISK.

NIPPLE PLAY SAFETY - ONLY USE BIPOLAR NIPPLE ELECTRODES AND ONLY USE ONE CHANNEL PER NIPPLE USING A CONTROL BOX WITH ISOLATED CHANNELS. IF YOU DO NOT KNOW IF YOUR CONTROL BOX HAS ISOLATED CHANNELS, ONLY STIM ONE NIPPLE. YOU CAN USE TWO CONTROL BOXES FOR DOUBLE NIPPLE PLAY.

NIPPLE PLAY SHOULD ONLY BE CONDUCTED BY PEOPLE WHO KNOW THE RISKS, KNOW THEIR EQUIPMENT AND ONLY USE ONE CHANNEL PER NIPPLE FROM AN ISOLATED CONTROL BOX.

NIPPLE STIMMING IS EDGE PLAY AND SHOULD BE TREATED AS SUCH.

Instructions For Use

Fitting

You must ensure that your control box is switched off and power level knobs are set to their minimum position before fitting electrodes! Only use one channel per nipple and place electrodes as close to the nipple as possible.

  1. Connect your cable plugs (one channel) to each electrode surface in your clamp or to each pad if you are using pads with one channel per nipple.
  2. Apply conductive gel/lube to the contact surfaces touching your skin; this is not needed for self-adhesive electrode designs.
  3. Fit the electrode pads or clamp into place and tighten to secure it in place if using a clamp.
  4. Turn on your control box and adjust your controls.
  5. Enjoy and adjust the fit of your electrode during the session if required.

 Removal

  1. Ensure the output of your control box is set to zero, and ideally, switch off the control box before removing your electrodes.
  2. Unplug your cable, loosen your electrode and remove it.
  3. Wipe down the electrode to remove excess conductive gel. If using self-adhesive electrodes, place them back on their plastic backing sheet.

Cleaning

Wash in warm, soapy water and dry the electrode before storing it until your next session. The conductive rubber can be removed to aid cleaning, but when refitting it, use a push-pull action to minimise stretching of the conductive rubber. Do not use abrasive or caustic materials on the conductive rubber or plastic components.